Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Driver Board Replacement Printer Component, Software Item, LCD Display, Printer Button Page 43.
Driver Board Replacement
Caution: Do not remove any cable, card, or component without first unplugging the
Printer from the AC power source.
Caution: Failure to up load and down load parameters requires that all electronic
adjustments be performed, the Head Rank for both print heads be entered,
and the Waste Ink Pads be replaced.
Caution: Failure to insert foil cables correctly (fully and straight) will result in com-
ponent damage.
Verify that the Board has the following part # stamped on it:
2077149
1. Up load parameters to the “Parameter” flash card
1.1 Unplug Printer.
1.2 Insert the parameter flash card (Part # 1070167SP10K).
1.3 Plug in Printer.
1.4 Turn on the Printer and do not press any key. The up load will be performed.
2. Remove the old Board.
3. Install the new Board.
Caution: be careful not to damage any components on the bottom of the board. The
“mounting areas” that the board attaches too can scrape off small compo-
nents.