Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Control Panel Map Page 4.
1. Use the [SelecType] or [Paper
Source] to move up or down the menu.
2. Pressing the [Enter] button will move
you into the sub menu.
3. Pressing the [Pause] button will
move you back one menu item.
1. PRINTER SETTING MENU:
2. TEST PRINT MENU:
5. MAINTENANCE MENU:
3. PRINTER STATUS MENU:
4. PAPER CONFIG MENU:
6. HEAD ALIGNMENT MENU:
1. [PLATTEN GAP] - *AUTO, WIDE, NARROW,
2. [PAGE LINE] - *ON, OFF
3. [INTERFACE] - *AUTO, PARALLEL, USB, OPTION1, OPTION2
4. [CODE PAGE] - *PC437, PC850
5. [ROLL MARGIN] - *T/B 15MM, 3MM, 15MM
6. [PAPER SIZE CHK] - *ON, OFF
7. [PAPER ALIGN CHK] - *ON, OFF
8. [INIT. SETUP] - Exec. (This will reset the Printer Setup options to default values)
* DENOTES Default Values
Use [Paper Feed +] or [Paper Feed -] to change a value. Use [Cut/Eject] to confirm, save or execute the item.
1. [NOZZLE CHECK] - Print, press [Cut/Eject] to execute.
2. [STATUS CHECK] - Print, press [Cut/Eject] to execute.
3. [JOB INFO] - Print, press [Cut/Eject] to execute.
Use [Paper Feed +] or [Paper Feed -] to change a value. Use [Cut/Eject] to confirm, save or execute the item.
This menu allows you to view all the Status Check items on the LCD display without printing the Status Check page from the Test
Print menu.
Use [Paper Feed +] or [Paper Feed -] to move up or down the menu.
1. [Paper Number] - *Standard (range is 1-10)
2. [Cut Pressure] - *100% (range is 0% - 150%)
3. [Cut Method] - *3 Step, 4 Step
4. [Ppr Feed Adj.] - *0.00% (range is -1.00% - +1.00%)
5. [Drying Time] - *0.0sec. (range is 0.0sec. - 10.0sec.)
6. [Suction] - *Normal,Weak, Weakest
7. [Print Adj.] - *5 (range is 1-9)
** DENOTES Default Values
Use [Paper Feed +] or [Paper Feed -] to change a value. Use [Cut/Eject] to confirm, save or execute the item.
1. [BLACK INK CHANGE] - EXEC. press [Cut/Eject] to execute. (Executes the mode to change black ink).
2. [CUT REPLACE] - EXEC. press [Cut/Eject] to execute. (Executes the cutter replacement process).
Use [Cut/Eject] to confirm, save or execute the item.
1. [PAPER THICK.] - STD, XMM (where X= 0MM - 1.6MM)
1a. Once the thickness has been set, you can choose the head alignment pattern you want to perform. The options are:
a) Bi D ALL
b) BI-D LC
c) UNI-D
Use [Paper Feed +] or [Paper Feed -] to change a value. Use [Cut/Eject] to confirm, save or execute the item.
SelecType Menu Options