Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Carriage Mechanism Replacement Printer Component, Software Item, LCD Display, Printer Button Page 37.
43.3 Press the Enter button time to display Adj: Check Skew.
43.4 Press the SelecType button to display Adj: Bi-d.
43.5 Press the Enter button to display [Enter] Adjust Print
43.6 Press the Pause button to display Bi-d V1, 240, K: nn (nn = current Bi-d value)
43.7 Press the + button to increase the Bi-d value by 1 (this forces the Printer to print the Bi-d V1, 240, K
alignment pattern. (To re-print decrease the Bi-d value by 1, etc.)
43.8 Compare one of the center Bi-d patterns against the images below, and adjust until the lines are as linear
as possible.
Paper Feed Direction.
Linear at the top
Non-Linear at the bottom
Non-Linear at the top
Linear at the Bottom
If the pattern is like this, move
the PF Slant Lever Down
PF Slant Lever
If the pattern is like this, move
the PF Slant Lever Up