Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Carriage Mechanism Replacement Printer Component, Software Item, LCD Display, Printer Button Page 36.
41.5 Press the Enter button to execute.
41.5.1 Move the A13 Slant Adjustment Lever to the left to move the Magenta lines closer to the leading
edge of the paper.
41.5.2 Move the A13 Slant Adjustment Lever to the right to move the Magenta lines farther from the
leading edge of the paper.
41.6 Adjust the A13 Slant Adjustment Lever until the magenta and black lines are linear.
42. Tighten the Print Head Fasteners.
It is important to tighten the Print Head Fasteners in the exact order listed below or the A13 alignment
will be altered. Do not over tighten.
42.1 Tighten the 2 Screws that fasten the 2 Spring Tension Brackets.
42.2 Tighten the 4 Screws that fasten the 2 Print Head Mounts.
42.3 Tighten the 2 Silver Plastic Screws that fasten the Print Head to the Print Head Mounts.
43. Perform the PF Slant Adjustment using the Bi d, V1, 240,K alignment pattern for reference.
43.1 Enter Self Diagnostic Mode.
43.1.1 Turn on the Printer while depressing Paper Feed + + Paper Feed - + Enter.
43.2 Press the SelecType button to display Check: Adjustment.
A13 Slant Adjustment Lever
(Shown without Print Head)