Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Carriage Mechanism Replacement Printer Component, Software Item, LCD Display, Printer Button Page 30.
30. Tighten the Carriage Belt to the marks on the Screws made in step 19(do not over tighten)
31. Adjust the Cutter Blade’s position, against the Cutter Guide (the thickness of a piece of paper.)
Tighten Screws to the marks made in Step 19.
Press here, and verify that
the Belt has about 1/8”
deflection
It is very important that you move
the Carriage Mechanism back and
forth while observing the Belts
position on the wheel. Adjust the
two tension Screws until the Belt
tracks with no drift (a little drift is
acceptable).
These Screws allow the
Cutter’s position to be
moved vertically.
Verify that the Cutter Blade
(when manually depressed) is
close to, but not touching, the
Cutter Guide.
Verify the Cutter Blade / Cutter
Guide position is good on both sides,
and in the middle of the Mechanism