Service manual
Stylus Pro 10600 Field Repair Guide 7/29/04
Control Panel Map Page 3.
Control Panel Map
Settings Available:
1. VIEW COUNTERS MENU:
2. CLEAR COUNTERS MENU:
3. SERVICE CONFIG MENU:
**All other menus are for factory use**
NOTE: Although this is a
guideline to navigate through the
Service and User Menus, the
Service Manual, Technical
Bulletins or Users Guide may still
be needed to reference detailed
information on a setting or
adjustment listed.
Settings Available:
1. PRINTER SETTING MENU:
2. TEST PRINT MENU:
3. PRINTER STATUS MENU:
4. PAPER CONFIG MENU:
5. MAINTENANCE MENU:
6. HEAD ALIGNMENT MENU:
Maintenance Mode 2:
Press [Paper Source] + [Cut/Eject] +
[Paper Feed -] buttons while
powering on printer.
SelecType Mode:
While printer LCD shows Ready,
pressing the [SelecType] button
will cycle through each menu
selection.
Firmware Download:
Press [Paper Source] + [Cut/Eject] +
[Cleaning] buttons while powering on
printer.
Self Diagnostic Mode:
Press [Paper Feed+] + [Paper Feed -
] + [Cut/Eject] buttons while powering
on printer.
** While in this mode, pressing the
[Cleaning] button will Auto Cut roll fed
media
Settings Available:
1. HEX DUMP MODE:
2. LANGUAGE MODE]
3. UNITS :
4. Parallel I/F
5. IEEE1284.4 MODE:
6. INTERNAL JOB OOUNT:
7. AUTO NOZZLE CHECK MODE]
8.SSCL B/C : -
9.SSCL LC/LM
10.SSCL M/Y:
11. MW7=A
12. MW7 BALANCE MODE:
13. MW1 SELECT MODE:
14. MW2 SELECT MODE:
15. DEFAULT PANEL:
16. CARTRIDGE INFORMATION
17. SN Menu FACTORY USE
Settings Available:
1. Check: Test.
2. Check: Adjustment.
3. Check: Cleaning.
4. Check: Print.
5. Check: Parameter.
6. Check: Life.
Use the [Paper Feed-] or [Paper
Feed+] to move up or down the menu.
Once in this mode, the LCD will display F/W Download. At this point send the
IPL Data file (TPxxxx.IPL) to the printer via the copy command from a DOS
prompt using the following syntax: COPY /B Filename.UPG LPT1:
Once the
download is complete, the LCD will display F/W Update Complete.
For navigation
and details on
menu items, go
to page 6.
For navigation
and details on
menu items, go
to page 7.
For navigation
and details on
menu items, go
to page 7.
For navigation
and details on
menu items, go
to page 8.
Maintenance Mode 1:
Press [Pause] button while
powering on printer.
Pressing the [Item] button
will cycle through each
menu selection..