Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Carriage Mechanism Replacement Printer Component, Software Item, LCD Display, Printer Button Page 28.
28.2 Install the Top Bearing Tension Bar, Bracket, Encoder, and fasten loosely with 1 Screw.
28.3 Position the Encoder so that the Strip is 3/4 of the way in to the Sensor, and vertically centered.
28.4 Move the Carriage the entire length of the Carriage Rail and verify that the Sensor is not rubbing, and
centered along the entire length of the Encoder Strip.
1. Tension Bar
2. Bracket
3. Encoder and Screw
3/4 of the way into the Sensor,
and tighten the 2 Screws.
Centered so that the Strip
does not touch to top or
bottom of the Sensor, and
tighten 1 Screw