Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Print Head Cable Replacement Printer Component, Software Item, LCD Display, Printer Button Page 104.
Driver Board.
3. Remove the Old Cables from the Printer while preserving their configuration. (Tape them together
on the Print Head side, and on the Board side.)
4. Lay the New Cables next to the Old Cables, and duplicate the configuration of the Old Cables
(the folding and order).
5. Transfer the Connector markings on to the New Cables from the Old Cables.
6. Install the New Cables and verify the Connector markings match the Connector being used.
Mark these cables as you
disconnect them with their
connector number.
CN24
CN23
CN22
CN21
CN20
CN19
CN23
CN20