Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Print Head Replacement Printer Component, Software Item, LCD Display, Printer Button Page 102.
Inspect the pattern with a strong lens. The black and magenta lines should be within 1/2 a dot of each
other for the majority of the lines.
37. Tighten the Print Head Fasteners.
It is important to tighten the Print Head Fasteners in the exact order listed below or the A13 alignment
will be altered. Do not over tighten.
37.1 Tighten the 2 Screws that fasten the 2 Spring Tension Brackets.
37.2 Tighten the 4 Screws that fasten the 2 Print Head Mounts.
37.3 Tighten the 2 Silver Plastic Screws that fasten the Print Head to the Print Head Mounts.
37.3.1 Do not over tighten.
38. Check the A13 Slant adjustment pattern for any change.
38.1 If there is a change:
38.1.1 Loosen the Print Head and re-tighten (be more gentle).
38.2 Check the A13 Slant adjustment pattern again.
38.2.1 Repeat the process as necessary.
39. Re-install the Print Head Cover.
40. Print the adjustment patterns.
40.1 Press the SelecType button to display Adj: Test Print.
40.2 Press the Enter button to execute.
41. Verify that all alignment patterns are correct.
42. Perform all necessary electronic alignments.