Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Print Head Replacement Printer Component, Software Item, LCD Display, Printer Button Page 101.
30. Connect the ten Print Head Cables.
30.1 Connect the 6 foil Print Head Cables.
30.1.1 Ensure that the Cables are fully seated, and the Traces have not been damaged.
30.2 Connect the 3 Multi Pin Connectors.
30.3 Connect the Ground Wire.
31. Connect the 6 Ink Tubes.
Do not over tighten the Brass Nuts. Use your fingers, only.
32. Close the Front Cover.
33. Turn on the Printer while depressing the
Paper Feed + + Paper Feed - + Enter buttons (Self
Diagnostic Mode) and inspect the Print Head while it fills with Ink (look for leaks).
34. Enter the Print Head ID information.
34.1 Navigate to Check: Adjustment: Input Rank.
35. Perform a Nozzle Check.
35.1 Check: Adjustment: Nozzle Check.
35.2 Clean if necessary.
36. Perform the A13 Slant adjustment.
36.1 Check: Adjustment: A13 Slant.
36.1.1 Move the A13 Slant Adjustment Lever to the left to move the Magenta lines closer to the leading
edge of the paper.
36.1.2 Move the A13 Slant Adjustment Lever to the right to move the Magenta lines farther from the
leading edge of the paper.