Service manual
Stylus Pro 10600 Field Repair Guide 7/29/04
Print Head Replacement Printer Component, Software Item, LCD Display, Printer Button Page 100.
25. Photo copy the Print Head ID information on the new Print Head.
26. Install the new Print Head.
26.1 Be careful not to scratch the nose of the Print Head when installing.
27. Replace the Print Head Weights.
28. Replace the Print Head Alignment Tension Spring.
28.1 Rock the Print Head away from the Carriage Mechanism.
28.2 Place the Spring in position with a pair of needle nose pliers.
28.3 Rock the Print Head back into position, compressing the Spring.
29. Replace Print Head Fasteners, but do not tighten any of them fully.
If you completely tighten any of the eight Screws, the Print Head will not align (A13 Slant).
29.1 The 2 Print Head Mounts, and 4 Screws.
29.2 The 2 Sprint Tension Brackets.
29.3 The 2 course Screws that fasten the Print Head to the Print Head Mounts.
Head ID #1
Head ID #2Head ID #3