Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Carriage Belt Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 10.
Carriage Belt Adjustment
The following instructions are for the purpose of performing the belt tension adjustment when the 300g
Tension Gauge is not available. Recommended tension is 100g.
1. Remove the Left Side cover. (6 Screws)
2. If replacing or removing the belt, place a mark on the current position of the adjustment screws.
3. Tighten or loosen the screws evenly to increase or decrease the belt tension.
3.1 The belt should be in the center of the pulley and remain in the center when moving the CR assembly left to
right the distance of the mechanism.
4. Check the belt tension by pressing on the belt at the side frame in the area indicated.
4.1 The belt will flex approximately 1/8" before tension is felt.
NOTE: If the CR Timing belt tension is to loose, you may encounter carriage errors. A slight vibration may occur
on the far left side of the mechanism, tighten belt until vibration is eliminated.
Press Here