Service manual

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
DISASSEMBLY AND ASSEMBLY Disassembling the Printer Mechanism 86
Confidential
7. Remove the screws (x3) that secure the Printhead, and lift the Printhead upward.
Figure 4-55. Removing the Printhead
8. Disconnect the Head FFCs (x2) from the connectors (x2) on the rear of the
Printhead, and remove the Printhead.
Figure 4-56. Releasing the Head FFCs
C.B.P. 2.6x8 (4±1 Kgfcm)
1
2
3
Head ID
A D J U S T M E N T
R E Q U IR E D
Printhead
Do not touch nozzle surface
C A U T IO N
Head FFC
 Make sure that the FFC is connected properly.
 Tighten the screws in the order given in Fig. 4-55.
 Install the Head FFC Cover and Head Cable Cover as shown
below.
A D J U S T M E N T
R E Q U I R E D
 For replacing the Printhead, note down the head ID before
installing the Printhead.
 After removing/replacing the Printhead, make the specified
adjustments. (See Chapter 5 "ADJUSTMENT".)
Head FFC Cover
The bottom protrusions (x2) and the top
sliding sections (x2) must be in
alignment.
Head Cable Cover
Engage the protrusion in the rear with the
carriage first and then insert the top
protrusions (x2) to the hole of the carriage.