Service manual

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
DISASSEMBLY AND ASSEMBLY Removing the Circuit Boards 84
Confidential
 When installing the Power Supply Board, route the P/S
Connector Cable on the ribs of the P/S Assy as shown in Fig.
4-50.
 When installing the P/S Assy, put the ferrite core of the P/S
Connector Cable in the groove of the Lower Housing, and route
the P/S Connector Cable through the ribs (x3) of the Lower
Housing.
Figure 4-51. Installing the P/S Assy
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Power Supply Board, make the
specified adjustments. (See Chapter 5 "ADJUSTMENT".)
Rib
Groove
P/S Connector Cable
Ferrite core
Left side