Service manual

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
DISASSEMBLY AND ASSEMBLY Removal of Exterior Parts 71
Confidential
 When installing the Scanner Unit, route the following cables
through the grooves and ribs of the Middle Housing, and secure
the FFC with double-sided tape.
Figure 4-21. Routing the Cables
Cable/FFC Groove Number of Rib
Number of double-
sided tape
Scanner FFC A 5 2
Scanner CR Encoder Cable B 5 ---
Scanner CR Motor Cable C 5 ---
Grounding wire D 7 ---
Groove A
Groove B
Groove C
Groove D
Rear left
Insert slack cables
and FFCs into hole
Groove
Rib
Double-sided tape
 After routing the cables, put the ferrite core of the Scanner CR
Motor cable in the groove of the Middle Housing. (See Figure
4-19.)
 After routing the cables, secure them with acetate tape and
double-sided tape as shown in Fig. 4-19.
 After routing the cables from the Main Board side, insert the
slack cables and FFCs into the hole on the Middle Housing.
(See Figure 4-21.)