Service manual

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
DISASSEMBLY AND ASSEMBLY Disassembling the Printer Mechanism 105
Confidential
4.4.14 Waste Ink Pads
 Parts/Components need to be removed in advance
Upper Housing / Scanner Unit / Panel Unit / M/B Cover / Waste Ink Tray Assy /
Middle Housing / Printer Mechanism
 Removal procedure
1. Remove Waste Ink Pads (x3) from the Lower Housing.
Figure 4-108. Removing the Waste Ink Pads
 Route the cable of the CD-R Sensor as shown below.
Figure 4-106. Installing the Front Paper Guide Assy (1)
 See Fig. 4-104 and install the PF EJ Ground Spring.
 Make sure the four tips of the Front Paper Guide Pad are
placed on the Waste Ink Pad.
Figure 4-107. Installing the Front Paper Guide Assy (2)
A D J U S T M E N T
R E Q U I R E D
 After removing/replacing the Front Paper Guide Assy, make
the specified adjustments. (See Chapter 5 "ADJUSTMENT".)
 After replacing the Front Paper Guide Assy, be sure to perform
the required lubrication. (See Chapter 6 "MAINTENANCE".)
Printer front bottom left
Pull out the cable here
Tip
Tip
Bottom Side
Waste Ink Pad Position
Tip of Front Paper
Guide Pad
C A U T I O N
When removing the Waste Ink Pads, take extra care not to
contaminate the surrounding objects with waste ink.
Place the Waste Ink Pads (x2) by pushing them along the cut
portions to the full and make sure that they are free from floating.
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Waste Ink Pads, make the specified
adjustments. (See Chapter 5 "ADJUSTMENT".)
Waste Ink Pads