Service manual

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C

DISASSEMBLY AND ASSEMBLY Disassembling the Printer Mechanism 100

Confidential

4.4.11 Paper Eject Frame Assy

 Parts/Components need to be removed in advance

Upper Housing / Scanner Unit / Panel Unit / M/B Cover / Waste Ink Tray Assy /

Middle Housing / Printer Mechanism

 Removal procedure

1. Release the Head FFC from the Front Frame. (See Figure 4-86.)

2. Remove the screw that secure the Cable Holder Frame to the Front Frame. (See

Figure 4-87.)

3. Remove the screws (x2) that secure the Front Frame, and remove the Front Frame.

Figure 4-94. Removing the Paper Eject Frame Assy (1)

 Install the PG Left Cam by mating the D cut surfaces and with

the cam positioned outside so that it does not come in contact

with sensing area of the APG Sensor

Figure 4-92. Installing the CR unit (2)

 Install the CR Unit so that the guide is engaged with the frame.

Figure 4-93. Installing the CR unit (3)

 When installing the Cable Holder Frame, make sure that it is

positioned correctly in the front and back direction. (Fig. 4-87)

A D J U S T M E N T

R E Q U I R E D

 After removing/replacing the CR Unit, make the specified

adjustments. (See Chapter 5 "ADJUSTMENT".)

 After replacing the CR Unit, be sure to perform the required

lubrication. (See Chapter 6 "MAINTENANCE".)

With the cam

positioned outside

PG Left Cam

APG Sensor

Must not touch

the sensing area

Rear

Carriage guide

C.B.S. 3x6 (8±1 Kgfcm)

Front Frame

Protrusion