Service manual

EPSON Stylus Photo 870/1270 Revision B
Disassembly And Assembly Disassembly Procedures 93
4.2.8 MOTOR ASSEMBLY, ASF Removal
1. Remove HOUSING (Refer to Section 4.2.1.)
2. Remove the harness for MOTOR ASSEMBLY, ASF from the main
board. (Refer to Section 4.2.2.)
3. Lower LEVER, PLANETARY UNIT.
Figure 4-21. Setting LEVER, PLANETARY UNIT
4. Remove the two screws (CBP, 3x8) securing MOTOR ASSEMBLY, ASF
to BRACKET, MOTOR, ASF. Then push the motor assembly to the rear
and then to the right to remove it.
Figure 4-22. MOTOR ASSEMBLY, ASF Removal
[Lever is held up.] [Lever is lowered.]
LEVER, PLANETARY UNIT
CHECK
PO INT
When installing MOTOR, ASSEMBLY, ASF5, make sure
the DE unit and LEVER, PLANETARY UNIT are set as
shown below:
CBP (3x8)
BRACKET, MOTOR, ASF
MOTOR ASSEMBLY, ASF
DE Unit (BRACKET,
MOTOR, ASF)
LEVER, PLANETARY
UNIT