Service manual

EPSON Stylus Photo 870/1270 Revision B

Disassembly And Assembly Disassembly Procedures 79

4.2.1 HOUSING Removal

Since the printer mechanism itself structures the bottom part, it appears

just by removing HOUSING.

1. Open the printer cover and set the PG adjustment lever to (+).

2. Remove the four screws (CBS, 3x10) securing HOUSING, and remove

it.

Figure 4-2. HOUSING Removal

CAUTION

When removing HOUSING, push it to the rear a little first,

and then lift it up.

CHECK

PO INT

When installing HOUSING, make sure the PG

adjustment lever is set to (+).

After assembling HOUSING, ensure the head

FFC is not caught in the back of HOUSING.

CBS (3x10)