Service manual

EPSON Stylus Photo 870/1270 Revision B
TROUBLESHOOTING Overview 60
3.1.1.3 Remedies for Paper Out Error
This section provides checkpoints and corresponding actions to take
when a Paper Out error occurs for either of the following reasons:
!
Paper is set in the ASF hopper but not fed.
!
Paper is loaded but not detected by the PE sensor actuator.
Be sure to follow the steps in the order listed in the table.
NOTE:
If the exhibited problem is similar to a problem listed under
“Problem”, take the actions in the right column. If not, proceed to the
next step.
Table 3-5. Remedies for Paper Out Error
Step Problem Check & Actions
1 Load/Eject button is
pressed but paper is
not loaded even
when the ASF LD
rollers turn, and a
Paper Out error is
displayed.
1. Set a cleaning sheet in the ASF up side down.
2. Holding the top edge, press the Load/Eject
button to remove micro pearl from the paper
load roller.
To remove severe soiling, staple a cloth
moistened with alcohol to a postcard and clean
the roller in the same manner.
2 The Load/Eject
button is pressed
and the ASF LD
rollers turn. But
they turn again to
send paper beyond
TOP position. Then
a Paper Out error is
displayed.
Check if the connector (yellow, 3-pin) for the PE
sensor is connected to PE sensor or CN5 on the
Main Board.
Non-adhesive Area
Cloth moistened
with alcohol
Adhesive Area
This side down
Staples
CL Sheet
Base Sheet
(Postcard)
Base Sheet
(Postcard)
Non-adhesive Area
Torsion Spring
PE Sensor
Connector
<Printer Bottom>