Service manual

EPSON Stylus PHOTO RX500/510 Revision C
Adjustment Adjustments by Adjustment Program 65
5.2 Adjustments by Adjustment Program
5.2.1 Overview
This machinery is adjusted by using specialized adjust program. Adjusted revision
figure is written into EEPROM of Main Board.
 Operating environment
 OS : Windows98/Me/2000/XP
 Hardware : PC equipped with USB 1.1/2.0 I/F
 Program constitution
• SPRX500510_Ver10.exe (program main file)
• D4Comm.dll
• DataManu.dll
• OsSwitch.dll
• PrnDrv95.dll
• PrnDrv98.dll
• PrnDrvXP.dll
5.2.1.1 Installing the Adjustment Program
Copy the seven files listed above into any desired folder on the PC.
5.2.1.2 Starting the Adjustment Program
1. The following start screen is displayed when the adjustment program has been
started. Then select a model name, destination and port.
Figure 5-1. Adjustment Program Start Screen
2. Click the [OK] button.
3. Select the item to be executed by clicking the tab.
Figure 5-2. Adjustment Program Screen
 Quitting the program
Clicking the [Quit] button displays the window shown below.
 [Quit] button : Finishes the adjustment and closes the program.
 [Continue] button : Returns the program to the start screen.
Figure 5-3. Quit Screen
C H E C K
P O I N T
 Before installing this program, make certain that a USB
driver has been installed on the PC properly.
 Make sure that the seven files are contained in the same
folder.
C H E C K
P O I N T
While Stylus PHOTO RX500/510 is warming up (Power LED is
flashing), you cannot run the program (a communication error
occurs). Run the program after making certain that the Power
LED of the printer is lit.
Click a tab for selection
[Quit] button
[Get Status] button Acquires
printer information, and displays it
to the right.