Service manual

EPSON Stylus PHOTO RX500/510 Revision C
Disassembly and Assembly Disassembly and Assembly of Printer Unit 53
4.5.3 Printhead
1. Carriage Unit Removal. (p51)
2. Remove the Head Cable from the CSIC board, then remove the Head Cable from
the Holder I/C.
3. Remove the Printhead and Carriage from the Holder I/C.
4. Remove 2 screws that secure the Printhead.
5. Remove the Printhead from the Carriage.
6. Remove the Printhead from the Head Cable.
Figure 4-10. Printhead Removal
A D J U S T M E N T
R E Q U I R E D
After installing the Printhead, make the adjustment, referring to
the following:
 Adjustment Items for Individual Units and Components (p64)
Carriage
Holder I/C
Printhead
CSIC board
Head Cable
C.B.B TITE (P2), 2.5x8, F/Zn
Tightening torque:0.3 ± 0.05 N
⋅ m