User Setup Information

5. If the StylusColor II is shown, click OK. You see the Chooser
window.
If the wrong printer is shown, the printer may be turned
off or not connected properly. Turn on the printer, if
necessary, and check the connections; then click RETRY. If
the printer name is still wrong, change the port selection on
the Chooser window and repeat steps 2 through 5.
6. If you wish, turn on background printing by clicking the
button so you can print in the background while using
your Macintosh for other tasks. (You must turn on
background printing to use the Epson Monitor2 Utility to
manage print jobs, as described in Chapter 3.)
Note:
Your system must have at least 8MB of RAM to use background
printing. Background printing slows the print speed and may
also slow down any software program you use while printing in
the background.
7. To use the the printer with its serial connection, the printer
port, and the Bi-D Calibration Utility (described in
Chapter 3), you must make AppleTalk inactive by clicking
the Inactive button. If you used the modem port, you can
leave AppleTalk active.
8. Close the Chooser. You see a reminder message to change
the printer in your applications.
9. Click OK.
Now you can access the driver as described in the next section.
Installing and Using the Printer Driver
2-5