Parts User Manual

3-8
Installing EPSON Stylus RIP for Windows
To set up EPSON Stylus RIP for this networked environment,
install the RIP software on the print server as described in the
previous section, and then install only the PostScript printer
driver on the client computers on the network.
Follow these steps to only install the PostScript printer driver
on client computers:
1. Insert the EPSON Stylus RIP CD-ROM in the drive. The
install program starts automatically.
Note:
If the Adobe PostScript installer doesnt start automatically,
youll need to manually run the Adobe setup program from the
EPSON Stylus RIP installation CD. It is located at:
Windows 95/98: (CD-ROM drive):/Driver95/SETUP.EXE
Windows NT 4.0: (CD-ROM drive):/DriverNT/SETUP.EXE
2. When the Stylus RIP Installer dialog box appears, click
Exit
. The Adobe PostScript 4.2 or 5.0 Setup program starts
automatically.
3. Follow the instructions beginning on page 3-4 to install the
PostScript driver.
Do not select a
printer when
installing the
software on a
workstation. Click
Exit to only install the
PostScript driver.
Nflight.bk Page 8 Thursday, April 22, 1999 5:02 PM