Service manual

EPSON Stylus COLOR 480 Revision B
Disassembly and Assembly Disassembly 95
CHECK
POINT
n If the CR unit is disassembled or replaced with a new one, make
sure that the CR timing belt is set in the assembling groove
correctly as following figure.
Figure 4-54. CR timing belt setting position
ADJUSTM ENT
REQUIRED
n When you replace the CR unit with a new one, lubricate it with
the suitable amount of the G-55 grease by the specified position.
Refer to Chapter 6 Figure 6-4.
n When you replace the CR Pulley shaft with new one, lubricate it
with the suitable amount of G-26 grease by the specific position.
Refer to Chapter 6 Figure6-6.
n When removing or replacing the CR unit with a new one, adjust
the Gap (Bi-d). Refer to Page115.
Assembling groove
CR timing belt