Service manual

EPSON Stylus COLOR 480 Revision B
Disassembly and Assembly Disassembly 93
4.2.12 CR unit removal
1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Take the CR timing belt off the CR pinion gear by pushing the CR motor to the left.
Figure 4-48. Taking the CR timing belt off
3. Release the Printhead FFC from the cable holders on the LD roller shaft holder.
And disconnect the Printhead FFC from the connector CN4 on the Main board.
Figure 4-49. Taking Printhead FFC off
4. Release two CR guide shaft rod springs from the both hooks on the left and right sides
of the Main frame.
Figure 4-50. Release Left Rod spring for CR shaft
Figure 4-51. Release Right Rod spring for CR shaft
CR timing belt
Left CR guide shaft rod spring
Right CR guide shaft rod spring