Service manual

EPSON Stylus COLOR 480 Revision B
Disassembly and Assembly Disassembly 89
4.2.10 Paper Eject Roller removal
1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Remove three screws (C.B.S. 3x6, F/Zn screw,:2pcs, C.B.S, 3x5,F/CU screw) securing
the Front frame to the Main frame.
Figure 4-39. Removing the Front frame
3. Lift up the right side of the Front frame and slide it to the left side a little bit and then
remove it.
.
4. Slide the Paper eject roller carefully to the left side and remove the Paper eject roller to
the forward.
Figure 4-40. Slide the Paper eject roller
CAUTION
When removing the Front frame, if the CR unit is out of the CR
home position, the nozzle surface of the Printhead may come in
contact with Paper guide front as soon as the Front frame is
removed. This is because the CR unit is held with this frame.
Therefore, be sure to set the CR unit in the CR home position
before removing the Front frame. Otherwise, the dot missing
problem may occur.
C.B.S 3X6, F/Zn screw
C.B.S. 3X5, F/CU screw
CAUTION
Do not damage the tooth of the Spur Gear 15, EJ, with the round
hole on the Main frame.
Figure 4-41. Spur Gear 15, EJ
Paper eject roller
Step1
Step2
Paper eject roller
Spur Gear 15, EJ