Service manual

EPSON Stylus COLOR 480 Revision B
Disassembly and Assembly Disassembly 82
4.2.7 LD Roller removal
1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Take the Head FFC off from the Head FFC holder located along the LD roller shaft
holder.
Figure 4-21. Taking Head FFC out from the FFC holder
3. Remove two screws (C.B.S. 3x6, F/Zn screw) securing the LD roller holder to the
Main frame.
Figure 4-22. Removing two screws securing the LD roller holder
4. Push the two hooks of the LD roller shaft holder as shown in the following figure.
5. Pull the LD roller shaft holder unit upward from the Main frame.
Figure 4-23. Pushing two hooks of the LD roller shaft holder
6. Remove the LD roller along with the Clutch mechanism from the LD roller shaft
holder unit.
Figure 4-24. Removing the LD roller with Clutch mechanism.
Head FFC holder
LD roller shaft holder
C.B.S 3X6 F/Zn screws
Two hooks for LD roller holder
LD Roller
Clutch mechanism
LD Roller shaft holder unit