Service manual

EPSON Stylus COLOR 480 Revision B
Disassembly and Assembly Disassembly 80
4.2.5 Waste drain ink pad unit removal
1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Remove one screw (C.B.P TITE 3x8 F/Zn screw) on the front right side of the printer.
(viewed from front side)
Figure 4-17. Removing one screw securing the Waste ink pad unit
3. Remove one screw (C.B.P. TITE 3x8 F/Zn screw) and take three cables off from the
cable hook in the Waste drain ink pad unit as shown in the following figure.
Figure 4-18. Removing one screws & cables at the back side of the printer
4. Remove the Waste drain ink pad unit from the printer
.
Figure 4-19. Drain ink tube setting position
C.B.T TITE 3x8 F/Zn screw
Cable holder
C.B.S. TITE 3X8 F/Zn screw
Peel off the adhesive tape
CHECK
POINT
n After assembling the Waste drain ink pad unit, be sure to set the
following three cables in the cable hook in the Waste drain ink
pad unit. Refer to the Figure 4-18.
n When assembling the Waste drain ink pad unit, be sure to set the
tip of the waste ink tube in the suitable position of the Waste
drain ink pad. Refer to the Figure 4-19
ADJUSTM ENT
REQUIRED
When the Waste drain ink pad is replaced with a new one,
following service item is required.
n Waste drain ink counter reset operation. Refer to Page116.
n Tightening torque for screw
• C.B.P. TITE 3x8 screw for Waste drain ink pad unit : 9+/1 kgf.cm
Pump unit
Waste drain ink pad
Ink tube