Service manual

EPSON Stylus COLOR 480 Revision B
Troubleshooting Overview 54
Table 3-5. Error indication
Condition Status Monitor 3 Indication
Generic
Remedy
• Head cleaning
can not be
completed.
Figure 3-6. Head cleaning caution
Click “Yes”
button and
replace the
I/C by
following the
procedure.
• Head alignment
(bi-d) was not
performed.
Figure 3-7. Print head alignment was
not performed
NOTE: This error message is indicated
only this adjustment was not
performed in the Set up utility.
Once, this adjustment is
performed, this indication is not
indicated again.
Use the Print
head alignment
utility on the
printer driver
utility menu to
align the print
head.
Table 3-6. Error indication
Condition Status Monitor 3 Indication
Generic
Remedy
• Communication
Error
Figure 3-8. Communication error
1) Check the
correct printer
driver is
selected in the
printer setting.
2) Check the
parallel I/F
cable is
connected
correctly.
3) Disconnect
the AC cable
and connect it
again.
• General Error
Figure 3-9. General error
Motors or
circuit boards
may be broken.
Find out the
failure parts by
referring to the
“Unit level
troubleshootin
g”.