Service manual

EPSON Stylus COLOR 480 Revision B
Product Description Basic Specification 16
ENVELOP (PRINTABLE AREA)
Refer to the following table.
Table 1-4. Printable area for Envelop
NOTE: *1): Bottom margin can be set up to 3mm at minimum when the paper
length is designated with “ESC(S” command.) However, the printing
quality is not guaranteed in the area ranging from 3mm to 14mm, from
the form lower end. When the paper length is not designated, the bottom
margin must be wider than 14 mm.
*2): Bottom margin for color printing can be set up 3mm at minimum
when the paper length is designated with “ESC(S” command.). However,
guaranteed print area of color printing is narrow than BK
(monochrome)printing. This is due to the each color nozzles is assigned
in the one row nozzles.
Figure 1-4. Printable area for Envelop
1.2.4 PG Adjust Lever
Unlike other products, this printer dose not have the PG (Platen Gap) adjust lever in the
printer mechanism. So, the Platen Gap value can not be changed according to the paper
thickness.
Paper Size
Paper
Width
Paper
Length
LM RM/TM
BK
Bottom
Margin(*1
)
Color
Bottom
Margin
(*1,*2)
#10 241mm 104.8 mm 28mm 3mm
14 mm or
more than
3 mm
21mm or
more than
3mm
DL 216mm 279mm 7mm 3mm
14 mm or
more than
3 mm
21mm or
more than
3mm
C6 182mm 257mm 3mm 3mm
14 mm or
more than
3 mm
21mm or
more than
3mm
BM
TM
RM
LM
Printable area