Service manual

EPSON Stylus Color 400 Service Manual
Rev. A
3-
8
3.2.3 Removing the Operation Panel
1. Remove the housing. (Refer to 3.2.1)
2. Remove two screws (No.1) securing the operation panel and disconnect the operation panel from
the printer mechanism.
3. Remove one screw (No.1) and detach the left panel housing.
4. Remove two screws (No.3) securing the panel board assembly and take C206 PNL board out of
the panel assembly.
5. Disconnect the FFC from the connector on the C206 PNL board.
Removing the operation panel also disconnects the stacker assembly, since the operation panel holds
the stacker assembly.
WORK POINT
Stacker Assembly
Left Panel Housing
Panel Assembly
Panel Shield Plate
Panel Board Assembly
(No.1)
(No.3)
(No.1)
Figure 3-5. Removing the Operation Panel