Service manual

Chapter1 Product Description
Rev. A
1-2
0
1.4.2 Panel Functions
<
Panel Functions
>
Switch Function
Load/Eject
(Pushing within 2 seconds*)
Loads or Eject the paper.
When carriage is on the Ink Cartridge change position, return carriage
from Ink Cartridge change position.
Load/Eject
(Pushing for 2 seconds*)
Starts the Ink Cartridge change sequence.**
Moves the carriage to cartridge change position.
Cleaning
(Pushing for 2 seconds*)
Stars the Cleaning of head.
In the condition of “Ink Low” or “Ink Out” or “No Ink Cartridge” starts
the Ink Cartridge change sequence.**
Cleaning
(Pushing within 2 seconds*)
When carriage is on the Ink Cartridge change position, return carriage
from Ink Cartridge change position.
Note) * 3 seconds is required at the User’s manual.
** This function is not available in printing status.
<
Panel Functions with Power ON
>
Switch Function
Load/Eject Stars status printings.**
Cleaning Changes a Code Page.
Load/Eject
+
Cleaning
Enters the particular settings mode. (Factory use only.)
To enter the particular settings mode, it is necessary to push the
cleaning switch while Paper Out LED is blinking.(It blinks about 3
seconds)
Note) ** status printings prints firmware version, ink counter, selected code page and nozzle check
patterns.
<
Maintenance Error Reset
>
Switch Function
Cleaning Initialize EEPROM and reset timer IC.
Note) The next page explains the detail procedure of the EEPROM reset.
Table 1-15. Panel Function
Table 1-16. Panel Function with Power On
Table 1-17. Particular Setting Mode