Service manual

Chapter 1 Product Descriptions
Rev. A
1-
7
1.2.6 PG Adjust Lever Setting
The paper-gap (PG); a space between the printhead nozzle surface annd the paper
surface, can be adjusted to the appropriate level by the PG adjust lever which located
underneath the printer cover.
Table 1-5. PG Adjust Lever Setting
Paper Type Lever Position Gap Setting
Cut Sheet Front
(“0” position)
0 mm
Envelope Rear
(“+” position)
+0.62 mm
1.2.7 Paper Select Lever Setting
The built-in ASF is equipped with the adjust lever and the position of lever should be set to
appropriate position according to the type of paper used for the printing.
Table 1-6. Paper Select Lever Setting
Paper Feeding Paper Type
Source Select
Lever
Position
Cut Sheet Envelope
ASF Thick No OK
Normal OK No
Manual Thick OK OK
Insertion Normal No No
Paper Thickness Lever
(Forward position: Normal
Backward position: Thick paper)
Paper Thickness Lever
(Locate underneath the printer cover)
(Forward position: "0" Normal
Backward position: "+" Envelopes)
Figure 1-3. PG Adjust Lever and Paper Select Lever