Specifications

EPSON Stylus COLOR 200
Ink Jet Printers 6/96 EPSON Stylus COLOR 200-9
8. Press down the ink cartridge clamp until it locks in place.
You will feel some resistance.
c
Caution:
Once you install an ink cartridge, do not open the ink cartridge
clamp again or remove the cartridge except to replace it with
a new one. Once you remove a cartridge, do not reuse it.
Reusing a cartridge that has been removed may damage the
print head.
9. Press the
Load/Eject
button again to return the print head
to its home position. (Even if you do not press
Load/Eject
,
the print head moves back to its home position about
60 seconds after you close the clamp.)
The printer charges the ink delivery system for about two
minutes. During this time, the
Power
light flashes. When
the printer is finished charging, the
Power
light stays on.
c
Caution:
Never turn off the printer while the
Power
light is flashing.
Installing the Black Ink Cartridge
Follow these steps to remove the color print head unit and install
the monochrome print head unit and black ink cartridge:
1. Make sure the printer is on and the printer cover is open.
2. Hold down the
Load/Eject
button for about five seconds
until the print head unit moves left slightly to the ink
cartridge install position. The
Power
light flashes.
3. Raise the print head unit release lever as far as it will go.
c
Caution:
Do not lift up the ink cartridge clamp; the ink cartridge and
print head may become unusable.
4. Grasp both sides of the print head unit and carefully lift it
out of the printer. Place the print head unit on a flat, clean
surface.
c
Caution:
Do not touch the electrical contacts on the back and bottom of
the print head unit or inside the printer; you may damage
them.
5. Remove the monochrome print head unit from its storage
box by pressing on the notch as shown. Place the color print
head unit in the box. Always store the unused print head
unit in this box to protect its delicate components.
6. Carefully insert the monochrome print head unit into the
printer with the electrical contacts and print head facing the
back of the printer.
7. Press down the print head release lever until it clicks into
place.
c
Caution:
If the
Power
and
Ink Out
lights are flashing, remove the print
head unit (beginning at step 3) and reinsert it.
8. Open the ink cartridge clamp and remove the protective
paper sheet.
9. Lower the black ink cartridge into the print head unit with
the label facing up and the arrow on the top of the cartridge
pointing toward the back of the printer.
release lever