Specifications

EPSON Stylus COLOR 200
EPSON Stylus COLOR 200-8 6/96 Ink Jet Printers
w
Warning:
The ink cartridges are self-contained units. Under ordinary use,
ink will not leak from a cartridge. If ink gets on your hands, wash
them thoroughly with soap and water. If ink gets into your eyes,
flush them immediately with water.
c
Caution:
Do not open the ink cartridge packages until just before you
install them or they may become too dry.
Installing the Color Ink Cartridge
Follow these steps to install the color ink cartridge:
1. Make sure the printer is turned on.
2. Raise the printer cover by lifting the edges, as shown below.
3. Hold down the
Load/Eject
button for about five seconds
until the print head moves slightly left, to the ink cartridge
install position. The
Power
light begins flashing.
c
Caution:
Never move the print head by hand; always use the
Load/Eject
button to move it.
4. Raise the ink cartridge clamp to open the print head unit.
5. Remove the protective paper sheet.
6. Open the foil ink cartridge packages and take out the
cartridges. Remove the tape seal from the top of each one.
Set the black cartridge aside for now.
c
Caution:
You must remove the tape seal from the top of each cartridge;
leaving the tape on will permanently damage a cartridge. Do
not remove the clear seal from the bottom of the cartridge; ink
will leak out.
7. Lower the color ink cartridge into the print head unit with
the label facing up and the arrow on the top of the cartridge
pointing toward the back of the printer.
ink
cartridge
clamp
paper
sheet
color
cartridge
black
cartridge