Specifications

EPSON Stylus COLOR 200
EPSON Stylus COLOR 200-14 6/96 Ink Jet Printers
10. For each pattern you selected, the printer prints a Test
Alignment Sheet containing multiple samples of vertical
lines, each of which is assigned a number. One each sheet,
look for the sample that is most closely aligned.
Enter the number of the aligned sample or select
Not-
aligned
if none of the samples are aligned. Then select
Next
.
11. Repeat steps 9 and 10 until all patterns are aligned.
12. Select the Print Current Alignment Sheet checkbox to print
a final test sheet or select
Finish
to exit the Calibration Utility.
Replacing an Ink Cartridge
The printer's
Ink Out
light tells you when an ink cartridge is low
on ink and when you need to replace the cartridge. If the
Ink Out
light flashes, the cartridge is low on ink. If the printer
stops and the
Ink Out
light comes on, the cartridge is empty.
c
Caution:
Do not replace an ink cartridge unless the
Ink Out
light tells
you to. If you replace a cartridge before the light flashes, the
sensor that tells you when the ink is out will not work with
the new cartridge.
Leave the old cartridge installed in the printer until you are
ready to replace it with a new one. Attempting to print without
a cartridge installed can damage the printer.
When you discard your used ink cartridge, always remove it
from the print head unit first. Do not discard the print head
unit.
Once you install an ink cartridge, do not open the clamp or
remove the cartridge except to replace it with a new one. Once
you remove a cartridge, you cannot reuse it.
Use only these EPSON ink cartridges:
Black ink cartridge S020047
Color ink cartridge S020097
c
Caution:
Use only genuine EPSON cartridges and do not refill them.
Other products may cause damage not covered by EPSON's
warranty.
1. Make sure the printer is on and not printing, and the
Ink
Out
light is flashing or turned on.
2. Open the printer cover by lifting the edges on both sides.
3. Hold down the
Load/Eject
button for about five seconds
until the print head moves slightly left, to the ink cartridge
install position. The
Power
light begins flashing.
The print head unit returns to the home position if you do
not proceed to step 4 within 60 seconds.
c
Caution:
Never move the print head by hand; always use the
Load/Eject
button to move it.
4. Raise the ink cartridge clamp to open it. The cartridge rises
partially out of the printer.
5. Lift the cartridge out of the printer and dispose of it carefully
so any excess ink does not spill out. Do not take the used
cartridge apart or try to refill it.
w
Warning:
If ink gets on your hands, wash them thoroughly with soap
and water. If ink gets into your eyes, flush them immediately
with water.
6. Open the package containing the ink cartridge and remove
the cartridge from its foil wrapper. Remove the tape seal
from the top of the cartridge.
c
Caution:
You must remove the tape seal from the top of the cartridge;
leaving the tape on will permanently damage it. Do not remove
the clear seal from the bottom of the cartridge; ink will leak out.
ink
cartridge
clamp
color
cartridge
black
cartridge