Specifications

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET NEXT
A
SR-600
Specification
(STANDARD)
18 17
6.2 User Options
Options below are not installed in the IM-600 before shipping. They may be purchased independently.
1) MSR Units
Two types of MSR are available: one for Japan and one for overseas markets. The card slot is
angled 20° from the plane of the LCD to allow easy access. Installation entails removing the
connector cover on the right side of the LCD unit (DM-LS121T), and affixing the MSR unit with two
screws.
Model Key Specification
DM-MS123 ISO Tracks 1, 2, and 3 compatible (for overseas)
DM-MS112 JIS II, Tracks 1 and 2 compatible (for Japan)
NOTE: MSR can be installed and uninstalled only with the power turned off. The connector cover
should be installed even when no MSR unit is installed.
2) Customer Display Units
A special DM holder (attached) at the center of the rear of the terminal is used for installation.
The customer display port is on the motherboard at the rear of the terminal.
The following model of the Epson customer display can be used.
Model Key Specifications
DM-D110 20-character × 2-line display
NOTE: Customer display unit can be attached and removed only with the power turned off.
3) Floppy disk drive units
An optional external 3.5-inch floppy disk drive can be connected for installing maintenance software.
The interface connector is at the right side of the front panel of the terminal.
Model Key Specifications
OI-S01 External floppy disk drive
3.5-inch, 720 KB/1.44 MB
NOTE: Floppy disk drive unit can be connected and disconnected only with the power turned off.
6.3 Precautions Related to Internal Components
1. CPU, DIMM, HDD
EPSON quality assuer the assembled CPU, DIMM and HDD in IM-600 under the EPSON shipping
condition.
In case a customer exchange CPU, DIMM and HDD, EPSON quality assure only for CPU, DIMM
and HDD which are purchased from EPSON.
2. Interfaces and expansion slot
EPSON guarantee that each interfaces(include the compact flash interface) and PCI expansion
slot are in conformity to each interface standards.
When customer use any equipment and/or any PCI boards connected to IM-600, please check
those functions with IM-600 by yourself. Please refer to the "EPSON Operational testing products
list" for your selection of any equipment and/or any PCI boards.
END