Specifications

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET NEXT
A
SR-600
Specification
(STANDARD)
17 16
6. OPTIONS
6.1 Factory Options
Options below are installed in the IM-600 before shipping. Specify the options when purchasing the
IM-600.
1) CD-ROM drive unit
Model Key Specifications
OI-S02 Thin-profile CD-ROM drive unit
IDE interface
With Eject button and access lamp
NOTE: The CD-ROM drive might be damaged if you adjust the LCD angle when CD-ROM drive is
open. The CD-ROM must be closed when you adjust the LCD angle.
2) Drawer Board
Cash drawer and external CRT interfaces are provided on a single board. By installing this board, a
cash drawer can be controlled independently of the TM printer, and a CRT can be used.
Model Key Specifications
OI-B08 Two cash drawer ports
One external CRT port
NOTE: OPOS ver. 1.95 does not support the two drawers since the OPOS cannot know each drawer
status simultaneously.
3) CompactFlash Board
This board is required to use a CompactFlash card, which can be installed in place of either the hard
drive or CD-ROM drive.
Two types of connector boards are planned: one for use where a CompactFlash card would replace
the CD-ROM, and be accessible for replacement and removal from the front panel. This board could
be installed only in the CD-ROM location (not the hard drive location).
Model Key Specifications
OI-S03-012
OI-S03-022
Board to enable using CompactFlash Card instead of CD-ROM drive.
Board to enable using CompactFlash Card instead of HDD.
NOTE: CompactFlash cards can be inserted and removed only with the power turned off. Doing so
with the power on could corrupt data stored on the card.