Confidential SR-600 Specification STANDARD Rev. No.
Confidential REVISION SHEET Sheet 1 of 2 The table below indicates which pages in this specification have been revised. Before reading this specification, be sure you have the correct version of each page. Revisions Rev. A Document Enactment Design Section Sheet Rev. No. WRT CHK APL Sheet Okizaki Takahashi Miyagawa I A II A III A 1 A 2 A 3 A 4 A 5 A 6 A 7 A 8 A 9 A 10 A 11 A 12 A 13 A 14 A 15 A 16 A 17 A TITLE Rev. Sheet Rev. Sheet Rev.
Confidential REVISION SHEET Sheet 2 of 2 REV. SHEET A All CHANGED CONTENTS The specifications of the IM-600 and the DM-LS121T are combined.
Confidential CONFIDENTIALITY AGREEMENT BY USING THIS DOCUMENT, YOU AGREE TO ABIDE BY THE TERMS OF THIS AGREEMENT. PLEASE RETURN THIS DOCUMENT IMMEDIATELY IF YOU DO NOT AGREE TO THESE TERMS. 1. This document contains confidential, proprietary information of Seiko Epson Corporation or its affiliates. You must keep such information confidential.
Confidential TABLE OF CONTENTS 1. APPLICATION......................................................................................................................................1 2. GENERAL DESCRIPTIONS ................................................................................................................1 2.1 Features.........................................................................................................................................1 2.2 Accessories...........................
Confidential 4.4 Circuit Board Configuration (IM-600) ...........................................................................................12 4.4.1 Motherboard ........................................................................................................................12 4.4.2 Video Board .........................................................................................................................12 4.4.3 I/O Board .................................................................
Confidential 1. APPLICATION This product specification applies to the SR-600 POS terminal system. 2. GENERAL DESCRIPTIONS 2.1 Features The IM-600 is a base unit of the SR terminal. Designed for use in hospitality, and other high-end establishments, it provides the following features; • • • • • • • • • • • • • • • • • • ® ® IBM PC/AT compatible ® TM Intel Celeron (PPGA package: up to 366 MHz, FCPGA package: up to 733 MHz) can be used. Two 168-pin DIMM sockets are ready for a maximum 512MB of memory.
Confidential 3. GENERAL SPECIFICATIONS 3.1 Summary of Specifications 3.1.1 IM-600 specifications CPU Memory Item Usable CPU types Specifications Celeron (PPGA package: up to 366 MHz) TM Celeron (FCPGA package: up to 733 MHz) Socket 370-pin socket Secondary cache 128KB built-in Main memory 168-pin DIMM slots × 2 maximum 512 MB 3.
Confidential Item Speaker Specifications Built-in monaural speaker with volume control BIOS APM/ Plug & Play / DMI Front key lock Locks the front cover and terminal cover to the chassis Backup battery Vanadium-lithium battery backs up the RTC Power supply Internal, 100 to 240 V / 50/60 Hz, 130 VA Case color EPSON dark gray, EPSON cool white *1: The supplied standard Ethernet controller can be disabled with a BIOS setting. *2: A total of four serial ports are provided.
Confidential 3.2 External Dimensions 310 (W) × 363 (D) × 277 (H) mm (including rubber feet, excluding LCD clamp) Figure 3.2.1 TITLE EPSON DM-LS121T overall dimensions SR-600 Specification (STANDARD) SHEET REVISION A NO.
Confidential 3.3 EMI and Safety Standards Applied 3.3.1 For North America EMI: FCC class A Safety standard: UL1950 CSA C22.2 No.950 3.3.2 For Europe CE marking: EMC: EN55022 class A EN61000-3-2 EN61000-3-3 EN55024 IEC61000-4-2 IEC61000-4-3 IEC61000-4-4 IEC61000-4-5 IEC61000-4-6 IEC61000-4-11 Safety: EN60950 This device can be damaged by surges induced by nearby electrical storms when connected directly to an external aerial LAN cable.
Confidential 3.4 Environmental Specifications 3.4.1 Temperature Operating: 5 to 35°C Storage: -10 to 50°C 3.4.2 Humidity Operating: 30 to 80% RH (no condensation) Storage: 30 to 85% RH (no condensation) 3.4.3 Vibration resistance When packed: Frequency: 10 to 150 Hz Acceleration: 19.6 m/s {2 G} Sweep: 10 minutes (half cycle) Duration: 1 hour Directions: x, y, and z 2 No external or internal damage should be found after the vibration test, and the unit should operate normally.
Confidential 3.5 Reliability 3.5.1 MTBF 33,000 hours (except HDD, fan) 3.5.2 Life 1) Cooling fan (IM-600) CPU fan: Power supply fan: 40,000 hours 27,000 hours 2) Hard Disk Drive (IM-600) 5 years or 20,000 hours, whichever comes first, with a maximum of 300,000 times of accessing the drive. 3) Cold cathode fluorescent tube for backlight (DM-LS121T) 40,000 hours or more (at 25 ± 5°C) Life is defined as when a brightness becomes a half-value. This cold cathode fluorescent tube is changeable.
Confidential 3.7 Power Supply 3.7.1 Power supply capacity to external devices Total power available to devices connected to the interface boards (PCI slots, COM1 and 2 ports, keyboard/mouse, customer display, and the USB ports) is as follows. Current drain must not exceed the capacity shown for each supply voltage: +5, +3.3, +12, –12 and +24 volts. Power Supply +5 VDC Table 3.1 Power Supply Capacities Used for PCI slots, COM ports, keyboard, FDD, USB Capacity 2.5 A +3.3 VDC PCI slots 0.
Confidential 4. BASE UNIT STRUCTURE 4.1 Terminal Front Panel (IM-600) KB/Mouse Reset Switch CD-ROM Eject Button CD-ROM LED Front Cover Lock Front Power Switch Figure 4.1 Floppy Disk Drive Connector Speaker Volume Control Front Panel Controls & Connectors 4.1.1 Front Power Switch This pushbutton switch at the lower left switches between power on and off. The switch is covered to prevent inadvertent operation.
Confidential 4.2 Terminal Rear Panel (IM-600) O | Power Supply Fan Customer Display I/F PCI Slot I/O Interface Main Power Switch Figure 4.2 Power Connector Terminal Rear Panel 4.2.1 Main Power Switch Power to the primary side of the power supply is applied through this switch. Power is turned off when the rear cover is removed, so this switch is normally kept in the ON position. The switch is not accessible externally, to prevent power being turned off inadvertently. 4.2.
Confidential 4.3 Structure of the LCD (DM-LS121T) Figure 4.3.1 shows an external view of the DM-LS121T system. POWER LED MSR connector HDD LED Backlight Brightness adjustment Buttons Figure 4.3.1 External system view 4.3.1 Indicators Two LEDs - POWER LED and HDD LED are on the lower side of the front panel on the main unit. Table 4.3.1 shows the meaning of each LEDs. LED POWER HDD Table 4.3.
Confidential 4.4 Circuit Board Configuration (IM-600) Video Board Motherboard Figure 4.4.1 Circuit Board Configuration (top) Drawer Board VR Board PCI Board I/O Board Figure 4.4.2 Circuit Board Configuration (bottom) 4.4.1 Motherboard The motherboard provides basic PC functions, and consists of the CPU, chip set, memory (DIMM), Super I/O and power circuitry. 4.4.2 Video Board This board consists of the video controller and a connector for the LCD cable. 4.4.
Confidential 4.4.4 PCI Board This board provides the PCI interface. motherboard. It connects via its own connector directly near the rear of the 4.4.5 VR Board This board consists of the Power and Reset switches, speaker volume control and keyboard/mouse interface. 4.4.6 Drawer Board (Option) This optional board may be installed to provide ports for two cash drawers and a CRT. This is a factory option which is installed in the SR-600. 4.5 Miscellaneous 4.5.
Confidential 4.6 Cautions 1. Cut edges of the metal case can become corroded depending on storage and operating conditions. 2. The AC cable must removed from the unit before (1) Replacing the CPU, hard drive, DIMMs and other internal devices. (2) Attaching or detaching options such as MSR, customer display and FDD. (3) Connecting or disconnecting the devices such as TM printers, barcode scanners and keyboard. TITLE EPSON SR-600 Specification (STANDARD) SHEET REVISION A NO.
Confidential 5. SOFTWARE SPECIFICATIONS 5.1 Available operating systems We are considering providing localized language support for the following operating systems: 1) 2) 3) 4) 5) ® Windows 95 ® Windows 98 ® Windows NT Workstation 4.0 ® MS-DOS 6.2 ® Windows 2000 5.2 Available Driver Software 1) 2) 3) 4) ® ® Video driver (for Windows 95/98 or for Windows NT 4.0) ® ® ® Touch panel driver (for Windows 95/98 or for Windows NT 4.
Confidential 6. OPTIONS 6.1 Factory Options Options below are installed in the IM-600 before shipping. IM-600. 1) CD-ROM drive unit Model Specify the options when purchasing the Key Specifications OI-S02 Thin-profile CD-ROM drive unit IDE interface With Eject button and access lamp NOTE: The CD-ROM drive might be damaged if you adjust the LCD angle when CD-ROM drive is open. The CD-ROM must be closed when you adjust the LCD angle.
Confidential 6.2 User Options Options below are not installed in the IM-600 before shipping. They may be purchased independently. 1) MSR Units Two types of MSR are available: one for Japan and one for overseas markets. The card slot is angled 20° from the plane of the LCD to allow easy access. Installation entails removing the connector cover on the right side of the LCD unit (DM-LS121T), and affixing the MSR unit with two screws.
