Specifications
REV.-A
[Step7]
[Step8]
Disconnect the following connectors, which connect the printer mechanism to the MAIN board;
CN 13 (Blue/6 pins),
CN 14 (White/6 pins), CN 12 (White/2 pins), CN15 (White/2 pins), CN 18
(FPC/26
pins), CN 17
(FPC/36
pins), CN 11 (White/3 pins), CN 10 (Blue/3 pins), CN9 (Yellow/2
pins),
CN8 (White/2 pins).
Remove the 4 screws (PRINTER MECHANISM MOUNTING SCREW) fastening the printer
mechanism to the HOUSING, LOWER.
CAUTION
When loosening the screws that fasten the printer mechanism, take sufficient care not to damage
the FPC.
[Step 9] Remove the printer mechanism.
M.
R
Figure 3-15. Printer Mechanism Removal
ASSEMBLY POINTS
Be sure to mate the connectors with each correct partner referring to the Table below.
Table 3-8. Connector Connection
Printer Mechanism Side
I
MAIN Board Side
Release detector (White: 2 Pin)
CN8
(White)
PE sensor
(Front; (Yellow: 2 Pin)
CN9
(Yellow)
TE sensor (Blue: 3 Pin) CN
10 (Blue)
PE sensor (Rear) (White: 3 Pin)
CN 11 (White)
Pump motor (White: 2 Pin) CN 12 (White)
TE motor (Blue:
6 Pin) CN 13 (Blue)
PF motor (White: 6 Pin) CN 14 (White)
CR motor (White: 2 Pin) CN 15 (White)
c
.
,.,.
,
.’
<’
.
● Refer to “ASSEMBLY POINTS” in 3.2.3 when inserting the pump tube into the wasted ink drain
tank.
“>.
u
3-16