Specifications

REV.-A
3.2.4 Printer Mechanism Removal
This section describes how to remove the printer mechanism.
WARNING
When working with the printer mechanism, take sufficient care in handling the ink.
Carefully read the precautions in 3.1.1 before beginning the work.
CAUTION
Discharge ink from the printer before removing the printer mechanism.
[Step 1]
[Step
2]
[Step 3]
[Step 4]
[Step 5]
[Step 6]
Remove the housing. (Refer to section 3.2. 1.)
Discharge the ink in the ink path of the printer mechanism. (Refer to section 3.1. 1.)
Unscrew 3
C.C.U. screws (M3 X 8) and 1 C.B.B. screw (M3 X 12) to remove the SHIELD PLATE,
I/F.
Printer Mechanism
C.C.U. Screws (M3 X 8)
MAIN Board
SHIELD PLATE, l/F
C.C.U Screw (M3 X 8) C.B.B. Screw (M3 X 12)
Figure 3-13. Removing SHIELD PLATE, l/F
Separate the pump tube from the wasted ink drain tank.
Remove the TUBE, SUPPLY, INK from the ink cartridge holder by removing the TUBE SET
SCREW that fastens the TUBE, SUPPLY, INK to the cartridge holder.
Remove the cords (connected to the DETECTOR
ASSY., INK CARTRIDGE and the DETECTOR
ASSY., INK) from the rear side of the printer mechanism.
z’
tridge
Holder
Figure 3-14. TUBE, SUPPLY, INK Removal
3-15