Specifications
REV.-A
ASSEMBLY POINTS
When assemble the
printhead, follow the procedures shown below.
[Step 1]
[Step 2]
[Step 3]
[Step 4]
[Step 5]
[Step 6]
[Step 7]
Verify that the PIN, ADJUST on the carriage is set in the direction as shown in the
Figurt
below.
r,
II
I
\
nn
PIN, ADJUST
Mark
Mark
l-l
I I I I
~.arriw
Figure 3-10. Setting PIN, ADJUST Direction
Engage the tube set screw and O-ring onto the TUBE, SUPPLY, INK.
Connect the TUBE, SUPPLY, INK to the
printhead
and tighten the TUBE SET SCREW with
a tightening torque of 1 kg (Refer to section 3. 1.2.).
Mount the
printhead on the carriage and fasten the
printhead
with 2 screws (CP (P) (M3X 8))
(See Figure 3-9.)
Attach the cover, TUBE to the frame, FRONT with the screw (CUP screw
(M3
X 8)) and
the
PRESSING PLATE, COVER SPRING, UPPER.
Loosen the screw (CUP screw
(M3
X 8)) which fasten the printhead along with the PRESSING
PLATE, COVER SPRING, UPPER and then adjust the PRESSING PLATE, COVER SPRING
UPPER until it is parallel to the COVER, TUBE.
Verify that the COVER, TUBE does not interfere with the
FPC
by manually moving the carriage
left and right.
Id
FPC
Figure 3-11. Setting PRESSING PLATE, COVER SPRING, UPPER
3-13