Specifications

REV.-A
[Step 6]
[Step 7]
Disconnect the connector that connects the interlock switch to the resistor at the rear of the
printer mechanism.
Raise the front side of the HOUSING, UPPER with the rear side held.
Figure 3-8. Housing Removal (3)
3.2.2 Printhead Replacement
This section describes the procedures for disassembly and assembly of the printhead.
[Step 1]
[Step
2]
[Step 3]
[Step 4]
[Step 5]
[Step 6]
[Step 7]
Discharge ink. (Refer to section 3.1. 1.)
Remove the housing. (Refer to section 3.2. 1.)
Remove C.B.S. screw
(M3 X 8) fastening the PRESSING PLATE, COVER SPRING, LOWER to
remove the PRESSING PLATE, COVER SPRING, LOWER.
Release the carriage lock. (Refer to section 3.1. 1.)
Disconnect FPC of the
printhead from 2 connectors on the carriage.
Remove 2 screws (CUP screw
(M3 X 8)) attaching the printhead to the carriage.
Loosen the TUBE SET SCREW attaching the TUBE, SUPPLY, INK to the
printhead to remove
the TUBE, SUPPLY, INK from the
printhead.
TUBE SET SCREW
X 8)
OWER
Corm
f!s’
n
;,. .,
,.. ‘,
Figure 3-9. Printer Head Replacement
3-12