Specifications

REV.-A
3.2 DISASSEMBLY AND ASSEMBLY
e
This chapter describes procedures for disassembling main components of this printer. Unless otherwise
specified, the disassembled unit or components can be reassembled simply by performing the
disassembly procedure in the inverted sequence. The assembly procedure is, therefore, omitted in this
manual. Cautions for the assembly procedures are shown as
“ASSEMBLY POINTS”. Adjustments
required after assembling are shown as “REQUIRED ADJUSTMENT ITEMS”.
r“’””’”’
● Be sure to read section 3,1 and follow instructions when attempting to disassemble the unit.
● Before disassembly, remove shockproof attachments used for transportation.
● Before disassembly, remove paper and ink cartridge.
This section consists of the following seven paragraphs.
(1) Housing Removal (2) Printhead Replacement (3) Wasted Ink Drain Tank Replacement (4) Printer
Mechanism Removal (5) Circuit Board Removal (6) Ink Cartridge Holder Removal (7) Printer Mechanism
Disassembly Refer to the exploded view of the printer in the APPENDIX for reference.
Da
3.2.1 3-11
3.2.2 3-12
I
] I-lousingRemoval [ I
I l%intheacll%placernent I
I I 1
I
I
I
EEEl
- , 323 I 3-’4
Printer Mechanism
Removal
I
I
I
I
Wasted Ink Drain Tank
Replacement
I
C7
*,,. J
. .
<.”
. .
3.2.5.2 3-18
I
POWER SUPPLY Soard
Removal
Figure 3-5. Removal/Disassembly Flow Chart
3-1o