Specifications

REV.-A
3.1 OVERVIEW
This section describes the various points to note when disassembling, assembling and transporting the
printer.
3.1.1 Precautions for Disassembling the Printer
Follow the precautions below when disassembling the printer.
WARNING
●
Disconnect the power cable before disassembling/assembling/adjusting the printer.
● Wear glasses to protect your eyes against ink. If your eyes or any injured part of body get ink,
wash it away with fresh water and see the doctor immediately.
● A lithium battery is installed on the main board of the printer. Be sure to observe the following
instructions in servicing the printer or in storing the service parts.
a. Keep the battery away from any metal or other batteries so that the electrodes of opposite
polarity may not contact each other. Otherwise, the battery may burn or lode from the
tremendous heat generated inside.
b. Do not heat the battery. Do not put it in fire.
c. Do not solder on any part of the battery except terminals.
(Doing so may result in leakage, burning, or explosion. The leakage may affect other devices
mounted close to the battery.)
d. Do not charge the battery. (An explosive gas may be generated inside, and causes burning or
explosion.)
e. Do not disassemble nor distort the battery. (The gas inside the battery may hurt your throat.
Leakage, burning, or explosion may also result.)
f. Do not mount the battery in the wrong direction. (It may result in burning or explosion.)
CAUTION
When repairing the printer, be sure to empty the ink inside the ink cartridge or used ink pack in
order to protect yourself against ink or to keep the printer clean.
Inform users on every occasion of the appropriate ways to transport the printer.
Use only recommended tools. We do not compensate for the damage of the printer resulted from
using improper tools.
Apply lubricants\adhesives as specified. (See Chapter 6.)
Make adjustments as specified. (See Chapter 4.)
● Never fail to read the details of precautions described below.
‘ANGER ~
Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type
recommended by SEIKO EPSON Co.. Discard used batteries according to government’s safety
instruction.
3-1