Specifications

REV.-A
3. Push-pull tractor feed (release lever in REAR PUSH POSITION or FRONT PUSH POSITION).
● The paper must be loaded from the front or rear entrance.
● Release the friction-feed mechanism.
● Attach the pull tractor unit.
O Ensure that there is no slack in the paper between the platen and the pull tractor.
● Precisely adjust the horizontal position of the pull tractor and push tractor.
● Paper for multiple copies must be spot pasted on both side of the perforation betvveen the tractor
holes.
● Do not perform reverse feeds greater than 1/6 inch.
● Do not perform a reverse feed after the paper end has been detected.
\
Rear Push Position
Release Position
Figure 1-3. Release Lever Positions
Paper specifications See tables 1-3, 1-4, 1-5, and 1-6
Table 1-3. Specifications for Cut Sheets
Width
182 mrn to 257 mm
(7.2 in. to 10.1 in.) (80 columns)
182 mm to 420 mm (7.2 in. to 16.5 in.) (136 columns)
Length
182 mm to 364 mm (7.2 in. to 14.3 in.)
Thickness 0.065 mm to 0.10 mm (0.0025 in. to 0.0039 in.)
Weight
14 lb to 22
lb (52.3 g/m2 to 82 g/m2)
Quality
Standard paper (photocopier paper, etc.)
Table 1-4. Specifications for Continuous Papers
Width
I 101 mm to 254 mm (4.0 in. to 10.0 in.) (80 columns)
I 101 mm to 406 mm (4.0 in. to 16.0 in.) (136 columns]
Quality
Stan jard paper
Thickness
0.065 mm to 0.10 mm (0.0025 in. to 0.0039 in.)
Weight
14
lb to 22 lb (52.3 g/m2 to 82 g/m2)
f-’
i..)
..:
1-4