Specifications

REV.-A

[Step2] Insert the thickness gauge (exclusively made by EPSON) between the platen and the

printhead,

and rotate the SHAFT, CR, MAIN so that the head is pressed lightly against the

head. When rotating the SHAFT, CR, MAIN, you can make use of the notch at the right side

of the shaft.

1.00 mm &O.05 mm

Prmthead

and

Carriage

Platen

SHAFT, CR, MAIN

Figure 4-4. Platen Gap Adjustment

[Step 3] Set the adjust lever to the normal paper printing position and tighten the FLANGE

NUT(M4).

[Step 4] Pull out the thickness gauge. If the thickness gauge does not come off easily, loosen the

FLANGE NUT

(M4) again and go back to Step 2.

[Step 5] Apply Neji-lock to the FLANGE NUT

(M4).

NOTE: Be sure to perform

printhead

slant adjustment (Refer to section 4.5.1) after the platen gap

adjustment.

4-3