Specifications

REV.-A
ASSEMBLY POINTS
When attaching the release lever to the FRAME ASSY., RIGHT, make sure that all the teeth of the
@
gap gear are fully engaged with the teeth of the release lever.
I
H-
Release Lever
I
INTERMITTED
Gear Posifien
I
Figure 3-37. Setting Release Lever
c
,: Z.,..
REQUIRED ADJUSTMENT ITEMS
If you have reassembled the carriage, make the following adjustment in the specified sequence.
(1) Timing belt tension adjustment (Refer to section 4.3.)
(2) Platen gap adjustment (Refer to section 4. 1.)
(3) Platen gap adjustment (Refer to section 4.2.)
(4) Printhead slant adjustment (Refer to section 4.5.1)
(5) Print position adjustment (Refer to section 4.5.2)
c
, \
,.
... ’
3-34