Specifications

REV.-A
ASSEMBLY POINTS
When attaching the FRAME ASSY., RIGHT to the PAPER GUIDE, make sure the SHAFT, RELEASE of
@
the PAPER GUIDE, RIGHT is set in the proper direction as shown below.
PAPER GUIDE
Figure 3-35. Direction of SHAFT, RELEASE
I
REQUIRED ADJUSTMENT ITEMS
If you have reassembled the carriage, make the following adjustment in the specified sequence.
(1) Timing belt tension adjustment (Refer to section 4.3.)
(2) Platen gap adjustment (Refer to section 4.1.)
(3) Platen gap adjustment (Refer to section 4.2.)
(4) Printhead slant adjustment (Refer to section 4.5.1)
(5) Print position adjustment (Refer to section 4.5.2)
c
. .
.“ , ,
,./”
(J
.-. ,
3-32